Photonic HPRL Mode D'emploi page 12

Never allow the device to operate unsupervised! The device may only be operated with the specified
supply voltage and the power supply adapter included in the scope of delivery. Only use as much
brightness as required for working. A higher brightness setting can irritate the eyes, stresses the object
and also reduces the service life of the device.
Always keep the ventilation openings of the device free to avoid causing any overheating. Ensure
that the free air circulation is not hindered by anything and that there is a sufficiently large gap between
the ventilation openings and other objects. Keep the environment of the device clean (above all, dust
and lint-free), so that any device fans cannot suck in any dirt.
ATTENTION: dangerous optical radiation, do not look into the light, can injure your eyes
The device emits light with a high intensity! Never look directly into the lamp or any light-emitting device
openings as you will risk injury to the eyes. The emitted light is absorbed by materials and converted
into heat. Never cover the light emission aperture of the device with the hand, any other parts of the
body or any materials. To illuminate objects correctly, always ensure there is a distance appropriate to
avoid thermal damage or fire.
Before cleaning, disconnect the product from the mains and allow it to cool for at least 15 minutes. Use
a dry cloth for cleaning or a cloth moistened with water or a 5% ethyl or isopropyl alcohol solution, but
do not use combustible or flammable liquids under any circumstances. Allow the device to dry thoroughly
before use. If any liquid penetrates the device accidentally, pull the plug immediately and bring the
device to a service point. If dust has collected on the ventilation openings, it must be removed carefully.
Excessively intensive cleaning or the use of solutions that are too concentrated can lead to scratches,
discoloration or other damage to the surfaces of the device.
12 | 28