Photonic HPRL Mode D'emploi page 11

Designated use
This product has been developed and is intended for illumination purposes in the sector of stereo
microscopy for industry and laboratory use. The applicable standards and guidelines are listed in the
Chapter "Technical data".
This product is attached to the microscope lens and illuminates the underlying objects. A lens focuses
the light to the desired working distance.
We would like to say thank you for choosing to purchase this high-quality product and wish you lots of
success whilst using it.
Instructions for your safety
The following danger symbols are used in this operating manual:
Warning of a danger area! Caution, please refer to documentation!
Warning of dangerous electrical voltage!
Warning of hot surfaces!
ATTENTION: Dangerous optical radiation! Do not look into the light!
This chapter deals with safety instructions that must be complied with when using the device. In your
own interests, please comply with all safety instructions that are listed on the device and in this manual.
The operating instructions must be read before using the device. It is recommended to store the
operating instructions close to the device to ensure that it can be read immediately by the user in case
of need. The user must inform a responsible person or the manufacturer immediately if there are any
changes in the operating behaviour or to any safety-relevant device components. The operator is
responsible for the correct use of the product and for the training of the user. The generally application
legal national safety and accident prevention regulations must be complied with in addition to the
supplementary user guidelines of the operator. The manufacturer is not liable for any damages due to
incorrect operation or non-compliance with the danger instructions!
Never open the device or its components, unless specifically indicated in this manual as you
could otherwise risk physical injury or damage. If necessary, contact your retailer. Technical
modifications to the device are not permitted under any circumstances and repairs should only be carried
out by the manufacturer or authorised service points. Only original spare parts must be used. Only use
original spare parts approved by the manufacturer for this product. Operate this product only with the
supplied power supply adapter and place the adapter so that it can be quickly disconnected from the
mains.
Do not operate the device in the vicinity of water or in rooms with extreme humidity. Do not spill any
liquids onto the device and do not push any foreign bodies into the product, you could be electrocuted
or cause damage to the device. Do not position any flammable materials in the direct vicinity of the
device. The device must be kept away from all sources of heat and is not approved for use in explosion
hazard areas! The device may only be used in closed rooms.
11 | 28