Publicité
Les langues disponibles
Les langues disponibles
On/off switch
Select the required country adapter and plug the supplied power supply adapter into the mains outlet.
Plug the supplied adapter to the socket (6) to switch on the power supply. The lamp can be switched on
and off by briefly pressing the button (3).
Brightness control
The brightness can be changed by turning the right encoder (2). By briefly pressing the same encoder,
a previously stored brightness value can be recalled. To set the memory value, first set the desired
brightness and the illumination pattern and then press the encoder (2) for approx. 2 seconds until the
LEDs flash briefly.
Segment selection
Press the left encoder (1) to select the following LED patterns:
Full circle | Semicircle | Quarter circle | Single LED | 2 Quarter circles opposite
th
Rotating the same encoder (1) rotates the selected LED light image in 1/8
circular steps. It can be
rotated in both directions.
Autorotation
If a luminous image is selected, an approx. 2 second long press on the encoder (1) starts the
autorotation. The rotation speed can be changed in this mode by turning the encoder (1). The
autorotation is terminated by briefly pressing (1) once.
Mounting and using the polarising filter (optional)
To attach polarisation filters or diffusers, screw the corresponding accessories from below into the thread
of the ring light. Make sure that the accessories are not screwed too tightly. Check that the polarising
filter cannot come loose from the ring light from twisting the analyser.
USB (optional)
Optional USB type C is available for remote control and integration into systems. For the commands
please see the attached document.
Foot switch (optional)
A connection for a footswitch is available as an option. The lamp can be switched on and off with this.
14 | 28
Publicité
