Photonic HPRL Mode D'emploi page 13

Operation
Unpack this product and remove any protective film. Save the packaging.
Carefully read the complete operating instructions and observe the safety instructions under all
circumstances!
Attention: If the encoders do not behave as described here, then perhaps the left-handed mode
has been activated as described in the "Settings" chapter (S3), whereby the functions of the two
encoders are interchanged. If at any point you are not sure, you can perform a factory reset, which is
also described in the "Settings" chapter.
Use only the supplied power supply adapter and check if it is suitable for your voltage supply.
Assembly of the ring lens
Select the working distance suitable for your application by placing the lenses A or B above the LEDs.
Lense A is factory preset.
Lense A (left of divider C) for working distances between 45-130 mm.
Lense B (right of divider C) for working distances between 80-300 mm.
The areas overlap, whereby from an 80 mm working distance the B lense produces more brightness.
Observe all safety instructions before moving the ring lens. Disconnect the ring light from the
mains. Make sure the LEDs cannot illuminate.
Loosen the 4 D screws using the SW2.5 Allen key and lift the ring lens gently. Do not touch any LEDs
or other electronic components. Now place the desired lenses A or B over the LEDs and tighten the 4
D screws carefully again. Make sure that the screws are not tightened too tightly.
Simply rotating the ring lens without lifting it can destroy the LEDs.
ESD workplace
When working with ESD-sensitive components, an appropriate cable must be connected to the ESD
socket (7). This serves to compensate the workplace potential.
13 | 28