Renkforce SB-E17 Notice D'emploi page 30

Use an optional cable cutting connector to very easily create a secure contact without separa-
ting the line of the reversing headlight.
For this, put the cable cutting connector around the voltage line of the reversing headlight; then
also insert the red conductor of the cable for voltage supply into the connector. Press the contact
bridge onto the lines with suitable pliers.
• Connect the black line of the voltage supply cable to a ground point (-) at the car body.
• Now connect the small white plug of the connection line to the socket „PWR" of the electronic unit.
• Connect the minus pole of the vehicle battery again and engage the reverse gear with the ignition on. The
parking system switches on automatically and is ready for use.
30