GE IM6D Manuel Du Propriétaire Et Instructions D'installation page 49

Troubleshooting Tips... Before you call for service
Problem
Leaking water around
the fill cup
Leaking water behind
the refrigerator
Slow ice/freezer not cold
enough
Ice cubes too small/
slow ice
Ice cubes not landing in
bucket
49-60704-2
Possible Causes
Foam in the fill cup from
installing the fill tube.
Fill tube not correctly seated
in the fill cup.
House supply not properly
connected to the water
valve.
Water line not connected to
the water tube inlet.
Door left open.
Temperature control not set
cold enough.
Water shutoff valve
connecting refrigerator to
house water line may be
clogged.
Water line kinked.
Icemaker cord causing
icemaker/ bucket
misalignment
What to Do
it through the back of the
refrigerator, it may have picked
up pieces of foam as it was
pushed through. This foam can
make sure there are no foam pieces.
water valve. See Water line installation instructions.
Check that the plastic water line
running from the valve to
attached with the water
line.
Check to see if package is holding door open.
See About the Temperature Control in the Owner's
Manual of the refrigerator.
the water pipe to connect the water
hole may result in reduced ice
production or smaller cubes. See
Check that the plastic water
line running from the valve
to the water tube inlet is
kink in the water line will
icemaker.
Be sure icemaker power cord is in the hook as stated in
Fill Tube
Fill
Tube
Fill Cup
Water
Hose Clamp
Water Line
in water pipe
Adhesive-backed
Fasteners for
Water Tube
49