GE IM6D Manuel Du Propriétaire Et Instructions D'installation page 31

INSTALL THE MOUNTING SCREWS
4
Skip to Step 5 if screws are already in place in
the freezer side wall.
head screws
in the holes in the side wall.
The screw heads should extend
side wall.
INSTALL THE ICEMAKER FILL CUP
5
icemaker fill cup
into the icemaker as shown.
PLUG IN THE ICEMAKER
6
Holding the icemaker in place, insert the icemaker
power cord plug into the socket on the rear wall,
making sure the prongs and holes are matched.
Press the plug firmly into the socket. Lock the plug
in place by clipping the restraints onto each side of
the plug. Make sure the restraints click into place.
Make sure the power cord is still in the hook on
the back of the icemaker.
Hook
49-60704-2
Installation Instructions
Phillips
13
MOUNT THE ICEMAKER
7
side wall.
Make sure:
The power cord is still firmly in the socket.
The fill tube extends into the fill cup opening on
refrigerator to make sure the fill tube has not
been pushed out of the back of the refrigerator).
The icemaker mounting screws are located in
the uppermost position of the mounting slots.
The icemaker is level.
The icemaker power switch is set to OFF.
THEN SECURELY TIGHTEN THE ICEMAKER
MOUNTING SCREWS.
16
RE-INSTALL THE SHELF SUPPORT,
8
BUCKET, SHELF AND BASKET
Replace the center vertical shelf support, ice
bucket, chiller shelf and storage basket by
reversing the steps in Step 1.
ATTACH WARRANTY LABEL
9
A label
date of installation for warranty purposes. Apply it
to the back of the refrigerator.
KEEP THIS MANUAL
10
The warranty for the icemaker is printed in
this manual. Keep this manual with your
Refrigerator Owner's Manual.
The icemaker installation inside the freezer is now
complete. Continue to the Water Valve Assembly
section.
E
31