GE IM6D Manuel Du Propriétaire Et Instructions D'installation page 41

WATER VALVE ASSEMBLY INSTALLATION INSTRUCTIONS
U V
of the refrigerator—
BEFORE YOU BEGIN
Read these instructions completely and carefully.
WARNING
To reduce the risk of
electric shock or injury during installation,
you must first unplug the refrigerator
before proceeding.
TOOLS YOU WILL NEED
Flat blade and Phillips
screwdrivers
REMOVE THE COVER
1
Remove the compressor compartment access
the cover to the back of the refrigerator case.
Be sure to save the screws as the access cover
must be reinstalled later to ensure your refrigerator
will function properly.
WARNING
To reduce the risk of death or
electric shock, you must follow these
instructions:
Unplug the refrigerator before removing any
panels.
Do not damage any wiring while the panel is
removed.
Replace all parts and panels before plugging
the refrigerator back in.
49-60704-2
Installation Instructions
U , V or W
W T
or . For letter , go to page
Sharp knife
Pliers
36 for instructions.
ATTACH THE WATER VALVE
2
Locate the female connector plug. Plug the female
connector
water valve
terminal.
C
Fasten the water valve to the cabinet by driving
the hex-head screw
in the cabinet leg.
CONNECT WATER TUBE TO INLET
3
the kit with pliers and slide the clamp over the fill
tube assembly, located in the top right corner of
the refrigerator.
far as it will go.
Then slide the clamp downward to capture the
water tube in place.
Using one of the adhesive-backed fasteners
go and the
hose clamp is
Fill tube
not in place
assembly
over the fill
tube assembly,
then leaks are
possible.
Water tube
male terminals on the
4
15
Clamp
3
5
4
41