GE IM6D Manuel Du Propriétaire Et Instructions D'installation page 27

INSTALL THE MOUNTING BLOCK
4
plug buttons from the side wall.
Using the Phillips head screws
that are with the mounting
block, attach the mounting
block to the refrigerator by
driving the screws through the
outer holes on the block and
into the holes that the plug buttons were in.
from the kit in the inner holes on the mounting
block. On some models, the screws may already
be in place on the mounting block. The screw
mounting block.
INSTALL THE ICEMAKER FILL CUP
5
icemaker fill cup
into the icemaker as shown.
PLUG IN THE ICEMAKER
6
Holding the icemaker in place, insert the icemaker
power cord plug into the socket on the rear wall,
making sure the prongs and holes are matched.
Press the plug firmly into the socket. Lock the plug
in place by clipping the restraints onto each side of
the plug. Make sure the restraints click into place.
49-60704-2
Installation Instructions
13
MOUNT THE ICEMAKER
7
cup opening
mounting screws
Make sure:
The power cord is still firmly in the socket.
fill tube
refrigerator to make sure the fill tube has not been
pushed out of the back of the refrigerator).
THEN TIGHTEN THE ICEMAKER MOUNTING
SCREWS SECURELY.
C
INSTALL THE ICE BUCKET
8
Place the lower freezer
basket back into the
freezer drawer.
The upper freezer
basket is actually 2
baskets hooked together.
Remove basket on the
left by unhooking it.
Place the remaining
upper basket in the
freezer drawer on the right side. Place the ice
bucket in the left side of the lower basket.
ATTACH WARRANTY LABEL
9
A label
date of installation for warranty purposes. Apply it
to the back of the refrigerator.
KEEP THIS MANUAL
10
The warranty for the icemaker is printed in
this manual. Keep this manual with your
Refrigerator Owner's Manual.
The icemaker installation inside the freezer is now
complete. Continue to the Water Valve Assembly
section.
fill tube
icemaker on the two
19
E
27