GE IM6D Manuel Du Propriétaire Et Instructions D'installation page 32

WATER VALVE ASSEMBLY INSTALLATION INSTRUCTIONS S
of the refrigerator—
BEFORE YOU BEGIN
Read these instructions completely and carefully.
WARNING
To reduce the risk of
electric shock or injury during installation,
you must first unplug the refrigerator
before proceeding.
TOOLS YOU WILL NEED
Flat blade and Phillips
screwdrivers
REMOVE THE COVER
1
At the bottom rear of the refrigerator, remove the
Bend the cover back for access to the
compartment.
Be sure to save the screws as the access cover
must be reinstalled later to ensure your refrigerator
will function properly.
WARNING
To reduce the risk of death or
electric shock, you must follow these
instructions:
Unplug the refrigerator before removing any
panels.
Do not damage any wiring while the panel is
removed.
Replace all parts and panels before plugging
the refrigerator back in.
32
Installation Instructions
L M N Q R S T U V
Pliers Sharp knife
Tape measure
or W
2 CUT PLASTIC WATER TUBING
where it is secured to the water valve. Cut off
excess tubing with a sharp knife or single-edge
razor blade.
ATTACH THE WATER VALVE
3
Locate the female
connector plug
Slide the water valve
shield with ground
wire shipped with the
refrigerator completely
onto the water valve.
NOTE:
is missing from the water valve
shield, call 1.800.626.2002 and
Plug the female
connector
male terminals on the
water valve
wire can go on either
terminal.
valve to the cabinet
by driving the hex-
head screw
from the kit into the
hole in the cabinet
leg.
C
4
C
Cabinet
13
Water valve
bracket
49-60704-2