GE IM6D Manuel Du Propriétaire Et Instructions D'installation page 36

WATER VALVE ASSEMBLY INSTALLATION INSTRUCTIONS T
of the refrigerator—
BEFORE YOU BEGIN
Read these instructions completely and carefully.
WARNING
To reduce the risk of
electric shock or injury during installation,
you must first unplug the refrigerator
before proceeding.
TOOLS YOU WILL NEED
Flat blade and Phillips
screwdrivers
REMOVE THE COVER
1
to remove the compressor compartment access
attach the cover to the back of the refrigerator
case.
Be sure to save the screws as the access cover
must be reinstalled later to ensure your refrigerator
will function properly.
WARNING
To reduce the risk of death or
electric shock, you must follow these
instructions:
Unplug the refrigerator before removing any
panels.
Do not damage any wiring while the panel is
removed.
Replace all parts and panels before plugging
the refrigerator back in.
36
Installation Instructions
L M N Q R S or
Pliers Sharp knife
T
.
PLASTIC WATER TUBING
2
included in this kit by removing the tube from the
clip and pushing on
the bottom of the
disengaging the
tube and pulling it
from the valve.
Use the water line from the fill tube assembly
that came with the refrigerator. The water line is
attached to the fill tube assembly that is already
installed in the refrigerator. Remove the plug
from the end of the
waterline. Route the
water line through
the clip on the valve
pushing it into the
valve. The white line
will be barely visible if
properly engaged.
ATTACH THE BRACKET
3
EXTENSION TO THE WATER
VALVE
extension
screw
Clip
Water
line
Push up
Pull down
Clip
Water line
bracket
22
Bracket
extension
23
Quick-
connect
Quick-
connect
49-60704-2