GE IM6D Manuel Du Propriétaire Et Instructions D'installation page 18

ICEMAKER INSTALLATION INSTRUCTIONS N
of the refrigerator—
BEFORE YOU BEGIN
Read these instructions completely and carefully.
WARNING
To reduce the risk of
electric shock or injury during installation,
you must first unplug the refrigerator
before proceeding.
TOOLS YOU WILL NEED
Flat blade and Phillips
screwdrivers
REMOVE ICE CUBE TRAY SHELF
1
Remove the two screws securing the ice cube tray
to the side wall of the freezer. Remove the tray.
There are two white plug buttons above the screw
holes. Remove these plug buttons and install them
in the two screw holes that were used to hold the
ice cube tray shelf.
two Phillips head screws
that the plug buttons were in, but do not screw
them all the way in. The screw heads should
the freezer.
Plug
Buttons
18
Installation Instructions
L M N Q R S T U V
Pliers Sharp knife
16
or W
PREPARE FOR INSTALLATION
2
Remove and discard the large white plug from the
rear freezer wall. Pull out the gray insulation plug
and remove any debris.
Remove the outlet cover with a flat-blade
screwdriver..
INSTALL FILL TUBE
3
Cut the fill tube
N
knife or a single-edge razor blade.
Go to the back of the refrigerator.
On the tube side of the water
tube inlet
adhesive backing. Remove the
adhesive backing and slide the
tube into the hole near the top
at the back of the refrigerator.
Firmly press on the inlet to
secure it to the refrigerator.
SET POWER SWITCH TO OFF
4
Set the icemaker power switch to OFF. Leave
the power switch in the OFF position until the
refrigerator is connected to the water supply to
prevent premature operation.
Power
Switch
N length
template on page 47) with a sharp
20
19
49-60704-2