Publicité
Les langues disponibles
Les langues disponibles
Info
Observe distance to prevent the throttle grip from
getting stuck.
Cable routing
–
Route the cables of the heated grips on both sides along
the existing cable to the headlight mask.
–
Join plug-in connector
501661-01
–
Remove well nut
–
Join plug-in connector
–
Route the cable without tension and secure with a cable
tie if necessary.
501662-01
–
Position cover by guiding the plug-in connector of the
headlight through the opening.
Info
Make sure that the cables and wires are not clam-
ped.
501663-01
–
Hold the turn signal in area
the direction of travel, while pressing the cover tight at the
same time.
The cover engages with an audible click.
–
Repeat the operation on the opposite side.
501653-01
bo
together with both heated grips.
bp
.
bq
.
A
and carefully press against
ASSEMBLY 5
11
Publicité
