FUST NOVAMATIC EKI1221-IB Notice D'utilisation page 9

Important! There are some sounds during
normal use (compressor, refrigerant
circulation).
Problem
The appliance is noisy
The appliance does not
operate. The lamp does
not operate.
The lamp does not work.
The compressor operates
continually.
The compressor does not
start immediately after
pressing the Action
Freezeor Action Cool-
switch, or after changing
the temperature.
Water flows on the rear
plate of the refrigerator.
Water flows into the re-
frigerator.
Temperature cannot be
set .
The temperature in the
appliance is too low/high.
Possible cause
The appliance is not supported
properly
The appliance is switched off.
The mains plug is not connected
to the mains socket correctly.
The appliance has no power.
There is no voltage in the mains
socket.
The lamp is defective.
The temperature is not set cor-
rectly.
The door is not closed correctly.
The door has been opened too
frequently.
The product temperature is too
high.
The room temperature is too
high.
This is normal, no error has oc-
curred.
During the automatic defrosting
process, frost defrosts on the rear
plate.
The water outlet is clogged.
Products prevent that water flows
into the water collector.
Action Freeze or Action Cool
functions switched on.
The temperature regulator is not
set correctly.
The door is not closed correctly.
Solution
Check if the appliance stands sta-
ble (all the four feet should be on
the floor)
Switch on the appliance.
Connect the mains plug to the
mains socket correctly.
Connect a different electrical appli-
ance to the mains socket.
Contact a qualified electrician.
Refer to "Replacing the lamp".
Set a higher temperature.
Refer to "Closing the door".
Do not keep the door open longer
than necessary.
Let the product temperature de-
crease to room temperature before
storage.
Decrease the room temperature.
The compressor starts after a pe-
riod of time.
This is correct.
Clean the water outlet.
Make sure that products do not
touch the rear plate.
Switch off Action Freeze or Action
Cool manually, or wait to set the
temperature until the function has
reset automatically. Refer to "Ac-
tion Freeze or Action Cool func-
tion"..
Set a higher/lower temperature.
Refer to "Closing the door".
9