Gallagher SmartReader HR3 Manuel De L'utilisateur page 17

Setting up the SmartReader HR
Depending on how you intend using the SmartReader HR
one or more of the following procedures:
•• Setting the SmartReader operating mode, see Selecting an operating mode (p 18)
•• Setting the connection to Scale, see Connecting to the Scale (p 21).
•• Via Bluetooth (wireless)
•• Via cable
Note: You can also connect to a computer or other data logging device.
See “"Connecting the SmartReader to the computer”" in the SmartReader HR
Configurator Help.
•• Configuring slave devices. Refer to “"Bluretooth”" in the SmartReader HR
Configurator Help.
Operating modes
The SmartReader has two operating modes:
Memory Mode:
The captured Electronic ID tag data is stored in the SmartReader
in sessions until it is transferred to computer using the MyScale
Pro software.
If you are in Memory mode the following screen displays:
Non-Memory Mode:
1. If you are in Non-memory mode the following screen displays:
2. The captured Electronic ID tag data is immediately sent out
the Serial port (via Bluetooth or cable) to a Scale or data
logging device and not stored in memory.
All manuals and user guides at all-guides.com
3
you may need to perform
3
3
3
17