Removal Of Package And Cleaning; Sliding Mitre Saw Identification (Fig. 2) - Fox F36-257DB Notice D'utilisation

Scie à onglet radiale a double inclinaison avec lame ø255 mm et laser

Masquer les pouces

Table des Matières

Les langues disponibles

The machine is delivered into a carton packaging. Take out the machine and all the components from the

packaging. Peel the protection off, where present: the protection can be removed with a damp, soft cloth. Do

not use acetone, petrol or painting solvents

IMPORTANT : do not lift the machine by pulling the operating handle, because it could loose its

settings. Always lift the machine by the base or by the transport handle, if present

Should any part result defective or imperfect, do not use the machine in order not to compromise the efficiency

and the safety of the tool. Contact an authorised Service Centre to have the detective part replaced

Do not throw the carton before the machine is completely assembled

WARNING :

By cleaning the machine, after unpacking, do not use petrol or other petrol-based solvents

because extremely inflammable

The use of such products causes fire or explosion hazard

In general, all solvents used for machine cleaning are toxic if inhaled or ingested.

Always operate in well ventilated areas, away from potential sources of solvents. Wear a safety

mask

The machine is delivered with the cutting arm in transport position.

To release the arm, push it down, pull and turn the unlocking button (A) Fig.1.

List of parts contained in the packaging:

Mitre saw

Blade replacement wrenches

Vertical clamp

Set of spare brushes

Dust collection bag

A. Operating Handle

B. Start-up switch

C. Starter trigger

D. Lower Blade protection

E. Blade

F. Double beam Laser

G. Extensible supports

H. Rotating base

J. Bevel cut rotation handle

K. Rotating base graduation

L. vertical support base extensions