The Arm; Hands And Feet Position - Fox F36-257DB Notice D'utilisation

USE OF SETTING OF THE LASER SYSTEM
The laser system is controlled by switch (A) Fig.14.
WARNING !
Do not watch directly into the laser ray generator.
1. Draw a line on your work-piece.
2. Adjust the horizontal and bevel angles according to your needs.
3. Before camping the work-piece, switch the laser on and align the line you drew with one of the laser rays,
either on the right or on the left of the disk.
4. Turn on the mitre saw on.
5. Once the disk has reached the maximum speed, lower the head to cut.
To adjust the laser system in case it is not aligned with the blade proceed as follows:
1. Loosen the two screws on the side of the laser.
2. Block your work-piece on the base, turn on the mitre saw and operate a partial cut, to mark the two sides
of the cut.
3. Turn the laser till reaching a perfect alignment with the two cutting sides.
4. Once the laser is adjusted, tighten the screws (A) without moving the lasers.

THE ARM

During the use of the machine, the head must never be blocked in the lower position. The head can be blocked
in the lower position only for transportation or when it is not in function
To release the arm:
1. Push down gently the arm and keep it in this position.
2. Pull and turn the knob (B) Fig.16.
3. Lift up the arm to the upper position.
4. To block the arm in the lower position:
5. Lower down the arm to the lower position.
6. Pull and turn the knob (A) Fig.16.

HANDS AND FEET POSITION

Your cut will be easier and safer if you adopt a correct hands and body's working position. Stand on the side of
the machine, do not stand on the line of the chips ejection.
Keep a good and balanced position. Keep your hands at least 10cm away from the disk. Hold strongly the
•
work-piece against the guide and keep your hands in working position until the starter trigger has been
completely released and the disk has come to a complete stop
Before cutting:
•
- Do a test-cut with the machine off, to determine the path of the disk, or
- Switch the laser on and check that the path of the disk with the laser ray track. See the USE AND SETTING OF
THE DOUBLE LASER SYSTEM in case it needs to be adjusted.
WARNING!
- Do not cross arms in the disk area while cutting.
Make sure that the base and the angles are blocked before cutting.
EN
39