Assembly; Assembly Of The Rotating Base Handle; Bevel Fixing And Base Rotation; Assembling The Clamps - Fox F36-257DB Notice D'utilisation

WARNING!
Be sure that the mitre saw is switched off and disconnected from any current source before
assembly or any kind of adjustment.

ASSEMBLY OF THE ROTATING BASE HANDLE

Before using your double bevel mitre saw, you have to assemble the rotating base hande (J) Fig.2.
To do this, screw the handle (J). This handle is used to fix the rotating base at the desired angle for the
angle-cut.
WARNING!
Before cutting, make sure that this handle and the rotating base are blocked

BEVEL FIXING AND BASE ROTATION

The base can be blocked at 0° , 15° , 22,5° , 30° et 45° either left or right. When rotating the base, this will
automatically stop at the next position
To rotate the base, make sure that the rotating base handle is unblocked; then rotate the base at the desired
angle and block the rotating base handle in the new position

ASSEMBLING THE CLAMPS

Vertical clamp can be assembled either on the right or on the left of the blade and can be adjusted at the size of
the work-piece. Do not cut before having clamped the work-piece
Position the vertical clamp (A) Fig.3 by inserting the clamps spindle (B) into one of the holes located on the cut-
end guide, then tighten the knob (C) to fix the spindle.

USING THE CLAMP

1. The capacity of the clamp can be adjusted by releasing the knobs and sliding the spindles up and down.
Once the desired capacity is reached, tighten again the knobs.
2. while cutting, move the vertical clamp until the clamp's plate gets in touch with the work-piece
3. To block the work-piece against the base, screw the knobs until the work-piece is blocked. After having
cut, open the knobs to release the work-piece.
EN

ASSEMBLY

34