Electrical Connection; Electrical Connections; Extension Cables; Recommended Use - Fox F36-257DB Notice D'utilisation

Scie à onglet radiale a double inclinaison avec lame ø255 mm et laser

Masquer les pouces

Table des Matières

Les langues disponibles

ELECTRICAL CONNECTIONS

Use 230 V 50 Hz alternate voltage equipped with a ground conductor to supply your machine. Ensure that the

power supply corresponds to this voltage, that it is protected by a differential and magnetic thermal switch, and

that the ground system is efficient. If your machine does not work when connected to a socket, check carefully

the power supply features.

EXTENSION CABLES

Only use three conductors extension cables, with a plug with two plugs and a ground contact and sockets with

two holes and a earth corresponding to the plug of the tool. When using an electric tool at a remarkable

distance from the power supply, use an extension cable with sufficient dimensions to transport the current

which the tool needs. If the extension cable has not the sufficient dimensions a voltage drop can occur, thus

causing an overheating and a voltage loss. You can only use extension cables which are in compliance with CE

standards.

Extension cable length: ...................................................................................................................... up to 15 m

Cable dimensions: ............................................................................................................................ 3 x 2,5 mm²

Before using any kind of extension cable, check that it has not bare wires and that the insulation is not cut or

worn. Repair and change immediately it if it is damaged or worn.

WARNING:

Extension cables must be arranged away from the working area in order that they do not get in

touch with the work-pieces, the tool or other parts of the machine, thus creating possible risks.

WARNING:

KEEP THE TOOLS AND THE EQUIPMENT AT A SAFE DISTANCE FROM CHILDREN

This tool has been designed for cross and radial cutting wood and similar materials.

With the saw blade in a vertical position the maximum cutting height is 78 mm and the maximum cutting width

is 340 mm.

The head of the mitre saw can rotate from 0° to 45° both on the right and on the left for angle cutting. The saw

blade can be inclined at 45° on the left for inclined cutting.

The machine capacities are listed in the technical specifications table.

The machine is steady enough, however, it can be fixed onto a bench.