Publicité
Les langues disponibles
Les langues disponibles
Configuring the Switch Using the Console Port
Step 1: Connect a computer to the switch's console port using the supplied console cable.
Step 2: Start the terminal simulation software such as HyperTerminal on the computer.
Step 3: Set the parameters of the HyperTerminal: 115200 bits per second, 8 data bits, no parity, 1 stop
bit and no flow control.
Quick Connect
Protocol:
Port:
Baud rate:
Data bits:
Parity:
Stop bits:
Name of pipe:
Show quick connect on startup
Step 4: Enter the default username and password, admin/admin.
12
Serial
Flow Control
COM3
DTR/DSR
115200
RTS/CTS
8
XON/XOFF
None
1
Save session
Open in a tab
Connect
Cancel
x
Publicité
