Nose/Ear Hair Trimmer Attachment; Shaving Attachment - SilverCrest SHBS 3.7 C1 Mode D'emploi

Tondeuse à barbe et à cheveux 5 en 1

Table des Matières

Les langues disponibles

Comb attachments

• Remove the comb attachment. Rinse the comb attachment

with water and let it dry before using it again.

Hair trimmer, beard trimmer and precision trim-

mer attachments

1. Figure A: remove the attachment from the hair and beard

trimmer 5 by pressing it with the thumb towards the rear.

2. Remove the hair remnants from the attachment using the

cleaning brush 17 included in the delivery.

3. Apply a few drops of blade oil 16 to the cutting edge of the

attachment. Using a soft cloth, wipe off the surplus oil, if

necessary. Only use acid-free oil, such as e.g. sewing ma-

chine oil.

Nose/ear hair trimmer attachment

• Remove the nose/ear hair trimmer attachment 12. Rinse it

with water and let it dry completely before using it again.

WARNING!

Do not detach the shaving foil from the shaving foil frame,

and do not clean it using the cleaning brush 17.

NOTE: from time to time, oil the cutting blade with a few drops

of acid-free oil (e.g. sewing machine oil). Attach the shaving at-

tachment to the hair and beard trimmer 5 and let it run for a few

seconds without using it. Using a soft cloth, wipe off the surplus

oil, if necessary.

Table des Matières

Table des Matières

288911