Numark DMC2 Manuel D'utilisation Simplifié page 4

HOOKUP SCENARIO 1 – WITHOUT MULTICHANNEL AUDIO INTERFACE
If you do not own an audio interface with
multiple audio outputs, please study the
connection diagram on the right.
Connect the DMC2 to your computer
with the included USB cable.
Connect your computer's
output to a powered speaker system,
amplifier or headphones.
Hint: Most built-in
soundcards feature a 1/8" stereo
plug. Depending on your speaker
system, you may need to purchase
the appropriate cable connectors.
HOOKUP SCENARIO 2 – WITH MULTICHANNEL AUDIO INTERFACE
In this scenario, you are using an external
audio I/O interface with multiple audio
outputs, such as the Numark DJ|IO, via
USB or Firewire. Multiple output audio
interfaces enable you to send your master
mix and your CUE mix on separate audio
outputs, allowing you to take full advantage
of CUEing while you play.
If you own a multiple output audio interface,
please study the setup diagram on the
right.
Connect the DMC2 to your computer
with the included USB cable.
Connect your computer to your
audio interface with the proper cable.
(Please see your audio interface
documentation
connection).
Connect one pair of outputs on your
audio interface
speaker system or amplifier.
Connect your headphones to an
alternate audio output on your audio
interface.
Note: You will have to setup your
software and hardware so your mix
output is being sent to one stereo
output, while the CUE mix is being
routed to another.
the software
documentation for more information
on routing your audio outputs.
audio
computer
for correct
to a powered
Please consult
and hardware
2