gdw 1160 Instructions De Montage page 6

Hyundai / MitsubishiGallopper
1999 - ....
Ref. 1160
Fitting instructions
1) Remove the back part of the exhaust.
2) Detach the fuel tank and the protection plate at the back and tilt them a bit, so that you can unscrew the
bolt easily on both sides. (Attention: a full fuel tank has to be supported).
3) Insert the mounting tubes in the big openings at the back in the bottom of the chassis. Place the tow bar
with points (A) on the free screw-thread holes and insert the bolts and washers via the bottom. Insert at
points (B), that fit the inserted tubes, the bolts via the bottom, place the mounting pieces (-i) and (-j) in
between the tow bar and the chassis and place on top of the chassis mounting pieces (-e) with welded
nuts.
Tighten everything firmly.
4) Attach the protection plate and the fuel tank and install the exhaust, install the (*) and tighten everything
firmly.
Composition
1 tow bar reference 1160
1 flange ball 50T
2 bolts M12/1.25-35
2 bolts M12-120 + nuts
2 bolts M16-50 + nuts
1 security shackle 50T
4 washers 40-12-4
4 safety washers 12 mm
2 safety washers 16 mm
2 mounting pieces (-e)
2 tubes dia. 22 mm - 77 mm (-f)
1 mounting piece (-i) (50x50x15x2 mm)
1 mounting piece (-j) (50x50x15x4 mm)
Note
Please consult your cardealer or owners manual for the maximal permissable towing mass.
Remove any bitumen coating on the fastening position for the tow bar.
When drilling, be carefull not to damage any brake lines, electrical wiring or fuel lines.
(*)
(A)
(B)
(*)
(*)
(A)
(A-B)
(*)
(B)
(B)
(B)
(B)
All bolts and nuts: quality 8.8