Siemens MS40 Série Mode D'emploi page 8

en English
After each use, whenever the appliance is unsupervised, prior to
assembly, prior to disassembly, prior to cleaning and in the event
of an error, the appliance must always be disconnected from the
mains. Before replacing accessories or additional parts, which move
during operation, switch off the appliance and disconnect from the
power supply.
W Warning
Risk of injury
The blade is very sharp. Keep hands clear of the blade. After
switching off, the drive continues for a short time. Wait for the
blade to come to a standstill! After work, set cutting width to 0.
This appliance must be used with the sliding feed table and the
piece holder in position unless this is not possible due to the
size or shape of the food.
Before cleaning the appliance, pull out the mains plug and remove
the blade. Do not grip the blade by the cutting surface, but by the
blade attachment. If the power supply is interrupted, the appliance
remains switched ON and will start running again when the power
supply is restored.
W Caution
Motor may overheat! After a maximum 5 minutes of continuous use,
switch OFF the appliance and allow to cool down.
W Warning
Risk of suffocation
Do not allow children to play with packaging material.
Congratulations on the purchase of your
new Siemens appliance. You can find
further information about our products
on our web page.
8
Contents
Intended use ...............................................7
Safety instructions ......................................7
Your all-purpose cutter ...............................9
Cleaning .....................................................9
Storage .....................................................10
Disposal ....................................................10
Guarantee.................................................10