Olympus CAMEDIA C-2 Zoom Manuel De Base page 6

basic_e_d.fm Page 6 Tuesday, February 12, 2002 4:29 PM
Memory gauge
The memory gauge lights up when you take a picture. While the gauge is lit,
the camera is storing the picture on the card. The memory gauge indication
changes as shown below depending on the shooting status. When the
memory gauge is full, wait a few moments before taking the next shot.
When taking still pictures
En
Shoot
Before
shooting
(Gauge is
off)
When recording movies
Shoot
Wait
Before shooting
(Gauge is off)
Battery check
If the remaining battery power is low, the battery check indication on the
monitor changes as follows while the camera is turned on.
Lights up (Green)
Remaining power
level: high
6 En
Shoot
One picture More than
taken two taken
(Lit)
If you continue shooting
During shooting (Lit)
• Shooting is not possible until the lit area goes off completely.
• Movie recording ends automatically when the memory gauge
is full.
Blinks (Red)
Remaining power level: low
Replace with a new battery.
Shoot
Wait
No more pictures
can be taken
(Lit) (Fully Lit)
No indication
Green lamp and Orange
lamp on the right of the
viewfinder blink
Remaining power level:
exhausted