switel TC49S Mode D'emploi page 53

Quick dialling
It is possible to store 10 phone numbers so that they are dialled simply by pressing three buttons
(quick dialling).
Programming quick dial buttons
è
” STORE
ë
” STORE MEM
0
é
Making calls using the quick dial buttons
è
0
The phone number stored is automatically dialled.
Talk time display
A few seconds after a call has begun, the current duration of the call appears in the display in mi-
nutes and seconds.
Increasing the receiver volume
If the caller's voice is too quiet, you can increase the receiver volume during the call simply by set-
ting the receiver volume switch on the right−hand side of the telephone base
Setting the ringing tone volume
It is possible to change the volume of the ringing tone by adjusting the RING sliding switch on the
right−hand side of the telephone base. The sliding switch has three positions:
For loud ringing, move the sliding switch to the right−hand side (LAUT). For normal ringing volume,
move the sliding switch to the middle (KLINGEL). If you do not want to be disturbed, move the sli-
ding switch to the left−hand side (AUS), the ringing tone is switched off.
Muting the receiver microphone
The microphone in the receiver can be activated and deactivated during a telephone conversation.
—
Lift the receiver
Press the Store button
Enter the phone number (max. 16 digits)
Press the Store button
Enter the required memory location number
(e.g. in this case for memory location 0)
Replace the receiver on−hook / End programming
Lift the receiver
Press the quick dial button
Enter the memory location number (e.g. in this case, memory
location 0)
Press and hold the Mute button to activate the microphone,
release the Mute button to resume.
Telephoning
53