Hardware Installation - NEC MultiSync LCD1700M+ Manuel De L'utilisateur

Hardware Installation

To attach the MultiSync
instructions:
1. Make sure that the computer and monitor's power are both turned off. Please
follow the steps to install your LCD monitor.
a. Place monitor face down on a non-abrasive surface. Take off the rear cover,
then the base cover.
b. Connect the power cord to your LCD monitor. Then connect the audio
cable into the Audio Input of the monitor. Reattach base cover.
Bundle cables here.
c. Put rear cover back.
d. Plug the 15-pin Mini D-SUB cable into the signal connector of the computer.
LCD1700M
Black
® monitor to your system, follow these
3
5 1.2.26, 2:42 PM