Troubleshooting - NEC MultiSync LCD1700M+ Manuel De L'utilisateur

Troubleshooting

The image is blurred
• Refer to the Installation/Adjustment chapter and then select the correct
resolution, refresh rate and make adjustments based on these instructions.
• Do you use a VGA extension cable?
Remove the extension cable for the test. Is the image now in focus? If not,
optimize the image working on the description in the chapter, Installation/
Adjustment. It is normal for blurring to occur due to conduction losses in
extension cables. You can minimize these losses by using an extension cable
with better conduction quality or with a built-in booster.
• Does the blurring only occur at resolutions lower than the native (maximum) resolution?
Refer to the Installation/Adjustment chapter. Select the native resolution.
The image has a faulty color appearance
• It has a yellow, blue or pink appearance.
On the monitor press the "Enter" button and using the Fly-wheel move to the "color
settings" menu. Select the "Recall" item and press "Enter". If the image is still not correct
and the OSD also has a fault color appearance, then one of the three primary colors is
missing in the signal input. Now check the VGA cable contacts. If any pins are bent or
broken off, then contact your dealer or read the chapters for additional help and service.
No image can be seen
• Is the prompt on the display illuminated in green?
If the LED is illuminated in green, then press the "Exit" button on the monitor to
access the On Screen Display. If the message "NON PRESET MODE" appears
there, read the chapter Installation/Adjustment.
• Is the prompt on the display illuminated in orange?
If the LED is illuminated in orange, then the power management mode is active.
Press a button on the computer keyboard or move the mouse. If that does not
help, then check the VGA cable contacts. If any pins are bent or broken off,
then contact your dealer or read the chapters for additional help and service.
• Is the prompt on the display not illuminated at all?
Check the power supply mains socket, the external power supply and the main switch.
The image is or distorted, flashes or flickers
• Refer to the Installation/Adjustment chapter and select the correct
resolution, refresh rate and make adjustments based on these instructions.
The image is displaced in one direction
• Refer to the Installation/Adjustment chapter and then select the correct
resolution, refresh rate and make adjustments based on these instructions.
No Sound
• Check to see if speaker cable is properly connected.
• Check to see if volume in OSM is set at minimum.
LCD1700M
Black
13
15 1.2.26, 2:43 PM