Led Signals - GAPOSA ELECTRON QCzero Instructions

QCzero QCzeroP
30 EN

5. LED SIGNALS

9 LEDS inform about the status of the control unit and of its related systems. This gives the opportunity to easily verify if there
are any connection errors or devices' damages. In the following table there is an explanation of each led functions.
LED STATUS FUNCTIONS
It shows the power supply. It shows whether there is power supply.
ON
If off, then no power supply is provided to the control unit.
ON
UP
It shows the status of the OPEN terminal. (terminals 1-2).
OFF
DW It shows the status of the CLOSE terminal (terminals 2-3).
OFF
SS It shows the status of the Start/Stop terminal (terminals 4-5).
OFF
ST
It shows the status on the STOP terminal (terminals 5-6).
ON
ED
Shows the status of the safety edge (terminals 7-8).
ON
It shows the status of the safety beam (terminals 8 and 9).
PH
When the safety beam shows an obstacle then it switches off.
ON
Used for signals while programming.
TEST
During normal activity, it shows, if switched on, the performance of the safety beams' TEST.
OFF
LIGHT
It shows the status of the courtesy light terminal.
OFF
Control unit with integrated receiver