Programming Of The Working Time; Programming Of The Pause Time - GAPOSA ELECTRON QCzero Instructions

3.7.1 PROGRAMMING OF THE WORKING TIME

The working time is the time required by the door to completely open or close itself. By performing this procedure the control
unit learns automatically the door movement.
If programming is not performed the working time is 30 sec.
OPERATIONS
1. Verify the motor's rotation way and check that all limit switches are set! If during the procedure there is an activation of the
safety devices, then the motor stops.
2. Place the door at half way. Place the dip 1 and 2
in OFF position and then dip 6 in ON position.
3. Give a START/STOP (SS) signal, the door starts to open.
When opening is complete send a new SS signal.
4. Give a START/STOP (SS) signal, the door starts to close.
When closing is complete send a new SS signal.
5. Place the dip 6 in OFF position. Programming is finished.
3.7.2 PROGRAMMING THE PAUSE TIME (AUTOMATIC CLOSURE)
With the programming of the pause time the door can close automatically. Once memorized, the pause time can be modified
by repeating the procedure.
OPERATIONS
1. Place in ON the control unit's dip 8. The TEST led switches on.
2. Wait for the time you wish to set between the automatic closure and opening.
Max time: 4 min
3. Place in OFF position the dip 8. The TEST led switches off and the pause has been memorized.
Control unit with integrated receiver
PLACE
HALF WAY
1
1
QCzero QCzeroP
ON
TO
1 2 3 4 5 6 7 8 9 10
OFF
ON
1 2 3 4 5 6 7 8 9 10
TEST
ON
1 2 3 4 5 6 7 8 9 10
ON
TEST
OFF
EN 27
ON
2
2
OFF
ON