Lorex ACCWIFI1 Mode D'emploi page 27

Masquer les pouces Voir aussi pour ACCWIFI1:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

CLEANING
Clean the monitor and camera with a slightly damp cloth or an anti-static
cloth. Never use cleaning agents or abrasive solvents.
• Do not clean any part of the product with cleaners with thinners or
other solvents and chemicals. This may cause permanent damage to the
product, which is not covered by the Warranty. When necessary, clean it
with a damp cloth.
• Keep your product away from hot, humid areas or strong sunlight, and
do not get it wet.
Every effort has been made to ensure high standards of reliability for your
product. However, if something does go wrong, please do not try to repair it
yourself. Contact Customer Service for assistance.
DISPOSAL OF THE DEVICE
At the end of the product life cycle, you should not
dispose of this product with normal household waste, but
take the product to a collection point for the recycling of
electrical and electronic equipment. The symbol on the
product, user's guide, and/or box indicates this.
Some of the product materials can be re-used if you
take them to a recycling point. By reusing some parts or raw materials from
used products you make an important contribution to the protection of the
environment.
Please contact your local authorities in case you need more information
on the collection points in your area. Dispose of the battery pack in an
environmentally-friendly manner according to your local regulations.
NOTICES
WARNING: Any changes or modifications not expressly approved by the
grantee of this device could void the user's authority to operate the device.
FCC NOTICE
This equipment has been certified and found to comply with the limits
regulated by the FCC part 15, subpart C. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference,
and (2) this device must accept any interference received, including
interference that may cause undesired operation. This equipment has
been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference
to radio or television reception (which can be determined by turning
the equipment on and off), the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced radio or television technician for
assistance.
CAUTION: To maintain compliance with the FCC's RF exposure guidelines,
place the cradle at least 20cm (7.87in) from nearby persons.
CANADA/IC NOTICE
This device complies with Industry Canada licence-exempt RSS standard(s).
Operation is subject to the following two conditions: (1) this device may
not cause interference, and (2) this device must accept any interference,
including interference that may cause undesired operation of the device.
25

Publicité

Table des Matières
loading

Table des Matières