Kaiser Nienhaus 338000 Notice D'installation Et D'utilisation page 49

GB
FAQ list
Question: Why is the label on the first three outputs (motors) red on the JRM?
Answer: The red label serves to specially identify the outputs. Motors M0, M1, M2 can be connected together, or M0 and M1 can be connected
separately from M2 (e.g. for RCD protective switch). A phase leg (e.g. L1) must be connected to the L0 terminals to supply the motors with power
13
(230V~/50Hz).
Caution! The L0 terminals require the same potential!
Question: How long with the time be stored if the power fails?
14
Answer: Approx. 24 hours.
Question: Is it normal for the LED to flash?
15
Answer: Yes, a malfunction has occurred if it is ON or OFF!
Question: Is the input command "Sun sensor ON" repeated once the wind sensor has been released?
16
Answer: Yes!
Question: May the sensor or control lines be laid together with the motor lines in a single cable?
17
Answer: No, see the installation notes!
FAQ list
GB - 23