Kaiser Nienhaus 338000 Notice D'installation Et D'utilisation page 40

Operation and functions
Description of the pre-programmed functions
Motors with programmed timer (DOWN switch time) are moved DOWN in twilight when the sensor transmits an ON signal.
Notes:
Twilight sensor
– Automatic operation must be switched on before the twilight sensor will function correctly!
– If a twilight sensor is connected, it is automatically assigned to all outputs (motors)!
– If a twilight sensor is not used, a wire jumper must be connected to terminal I33 and 0V (as-delivered status).
All assigned motors move DOWN (with 1s slat adjustment for blinds) when the sensor transmits an ON signal. The motors move UP
when the sun sensor transmits an OFF signal. The sensor assignment and lowering time can be set for each motor (see Section 2.3)
Sun sensor Notes:
– Automatic operation must be switched on before the sun sensor will function correctly!
– A higher priority (button or sensor activated) DOWN function locks all motors with assigned sun sensor.
All assigned motors move UP and are locked when the sensor transmits an ON signal. This is particularly recommended for awnings!
All of the motors are unlocked again when the sensor transmits an OFF signal. The sensor assignment can be set for each motor
(see Section 2.3)
Wind-/ rain sensor
Note: If an input command "Sun sensor ON" is given while the wind/rain sensor is active, it will be executed once the OFF signal for
the wind/rain sensor has been given.
GB - 14
A higher priority (e.g. button central UP) UP function unlocks the motors again.
GB