Mounting And Installation; Safety Information; Mounting; Installation - Kaiser Nienhaus 338000 Notice D'installation Et D'utilisation

Mounting and installation

5. Mounting and installation

5.1 Safety information

Installation and commissioning may only be done by an authorised electrician. Mains power (230 V ~/50 Hz) to electrical equipment must be switched off
during installation. Applicable laws and standards of the country in which the device is operated must be observed!

5.2 Mounting

The 950 JRM is designed for mounting on a 35mm top hat rail acc. EN 50022 in in-/on-wall distribution housing. The devices can be mounted directly
next to each other.

5.2 Installation

See supplement „Installation".

5.3 Data link PHC Compact-System and 950 JRM

Compact 950 ACT Compact 950 JRM
 Bus In  Bus Out  Bus In  Bus Out
bus line
GB - 18
The link between the PHC Compact System and the 950 JRM is produced via a bus line and the bus connections
(RJ12) of the Compact modules.
The „Bus OUT " output of the 950 ACT must be connected to the "Bus IN " input of the 950 JRM.
Caution!! Switch off the power supply before disconnecting the bus line.
GB