General; Phc Compact System Description; Description Of The 950 Jrm - Kaiser Nienhaus 338000 Notice D'installation Et D'utilisation

General

1. General

1.1 PHC Compact system description

The PHC compact system facilitates building automation in which the user does not have to programme any components of the system. All of the functions
are preprogrammed and assigned to the input and output channels of the PHC Compact Modules, allowing the wiring to be run according to a function
table and terminal diagram.
PHC compact module Function of the PHC compact system
950EM, 950ACT Light functions
950JRM Venetian blind and roller shutter functions
950EM, 950ACT, 950JRM Light, Venetian blind and roller shutter functions
950FUC, 950ACT, 950JRM Light, Venetian blind and roller shutter functions

1.2 Description of the 950 JRM

The blind/shutter module (JRM) can control 12 servo powered blinds, shutters and awnings. They can be variably assigned to 3 groups (0-2). Manual ope-
ration is performed locally, centrally or in groups using dual buttons. Programmed timers can activate the outputs (motors) at specific times. In addition,
they can be activated by sensors, depending on the level of daylight or the weather. All of the JRM's functions are pre-programmed. After the power fails,
all the blinds/roller shutters are in an idle state. An LED in the top part of the module flashes when the operating voltage is applied.
GB - 2
GB