Starter Lever; Starter Lever Lock; Deflector Adjustment; Led Lights Switch - Stiga ST 4851 AE Manuel D'utilisation

3. Push until the pins fit into the specific holes
with a click.
4.6 CABLE GLAND ASSEMBLY
Insert the cable in the cable gland
(fig. 4.I) and fit it on the intermediate handle.
5. CONTROLS
5.1 IGNITION KEY
Used to start and stop the motor. The
ignition key has two positions (fig. 8.H):
1. Key removed - OFF - the motor stops and
cannot be restarted.
2. Key inserted - ON - the motor can start and
run.

5.2 STARTER LEVER

Used to start and stop the motor.
• Start: Press the lock button (fig. 8.C)
and pull the starter lever (fig. 8.B).
• Stop: release the starter lever (fig. 8.B).

5.3 STARTER LEVER LOCK

It prevents accidental activation of
the starter lever. Press the button
(fig. 8.C) to release the starter lever.
5.4 DISCHARGE CHUTE
ADJUSTMENT HANDLE
This controls rotation of the discharge chute
so that snow discharge can be aimed in the
required direction. Turn the handle (fig. 9.E)
clockwise/anti-clockwise to adjust the chute.

5.5 DEFLECTOR ADJUSTMENT

Hold the handle (fig. 10.A) and press it to release
the deflector lock (fig. 10.B) to enable deflector
regulation (fig. 10.C). Move the handle forward/
back to lower/lift the deflector, pulling the handle.
Once the deflector is brought to the
desired position, releasing your grip
blocks the deflector (click).

5.6 LED LIGHTS SWITCH

To turn the headlamps on, push
the switch (fig. 8.E) forward.
I = ON: lights on
O = OFF: lights off

6. USING THE MACHINE

IMPORTANT The safety regulations to
follow during machine use are described in
chap. 2. Strictly comply with these instructions
to avoid serious risks or hazards.
The machine is supplied without the battery.
Purchase the battery with the capacity that
most suits your operational requirements
and fully charge it according to the
instructions in the battery booklet.
The list of approved batteries for this machine
is found in the "Technical Data" table.
6.1 PREPARATION
• Check the auger has not already
taken in snow in the start position.
• Insert the battery in the specific
compartment (fig. 7 )
NOTE Before starting to clear the snow,
silicone spray should be applied to the auger
to avoid ice formation on the rotating units.

6.2 SAFETY CHECKS

After start-up and before using the machine,
it is essential to run the following safety
tests. Check the results of the safety
checks correspond to those in the table.
Always carry out the
safety checks before use.
6.2.1 General safety and auger
functionality check
Object
Press the release
button (fig. 8.C).
Press the starter lever.
Test driving
Release the starter lever.
If any of the results fails to match
the indications provided in the following
table, do not use the machine! Take
it to a service centre to be checked
and repaired if necessary.
EN - 8
Result
The motor starts and the
auger starts to rotate.
No abnormal vibrations.
No abnormal sound.
The motor and auger
stop immediately.