Campbell Hausfeld WG3080 Instructions D'utilisation Et Manuel De Pièces

Operating Instructions and Parts Manual
Wire Feed
Arc Welder
Models: WG3080, WG3090 and WG4130
1
Figure 1 - Welder Components and Controls
Description
These Campbell Hausfeld wire feed welders are designed to be used on standard 120V
(WG3080 and WG3090) or 230V (WG4130) outlet. The welder is equipped with infinite
wire speed control to accurately select the proper wire feed rate needed for various
welding conditions. Internal components are thermostatically protected.
This welding system is designed for use with the Flux Cored Arc Welding (FCAW) or
the Gas Metal Arc Welding (GMAW) process. As delivered from the factory, this welder
can weld with .030 in. (0.8mm) diameter flux core wire. A starter spool of .030 in.
(0.8 mm) flux cored wire is included.
To use the GMAW process with the WG3090 and WG4130, it is necessary to purchase
shielding gas and MIG wire only. With the WG3080, a regulator/hose kit must be
purchased in addition to the shielding gas and MIG wire.
© 2013 Campbell Hausfeld/Scott Fetzer
3
5
6
4
For parts, product & service information visit
www.campbellhausfeld.com
CirCuit requirements
120 volt or 230 volt circuit (depending
on model). Refer to the following chart
for correct circuit breaker or fuse
rating for 120 volt models. Do not run
other appliances, lights or tools on this
circuit while operating this equipment.
Extension cords are not recommended.
Blown fuses and tripped circuit breakers
can result from failure to comply with this
recommendation.
Components and Controls
(Figure 1)
1. Work Clamp – connects to work
piece.
2. Torch with .030 in. tip.
2
3. Power Cord – plug into 120 volt or
230 volt outlet (depending on model).
4. Light – illuminates if thermostat has
automatically shut welder off.
5. Infinite Wire Speed Control – turn
clockwise to increase wire speed and
counterclockwise to decrease wire
speed.
6. Off/Heat Selector - Selects welding
power and turns welder on.
Five selections are possible:
1 – 2 – 3 – 4 – 5.
Heat
selector
1-2-3
4-5
See page 8 for supply cable replacement
instructions.
This equipment
requires a dedicated
Circuit Breaker or
slow Blow Fuse for
120V models
15 amp
20 amp
IN974201AV 11/13