Inserting The Bobbin - Janome Sew Mini Livret D'instructions

Inserting the bobbin

q
Place the bobbin in the bobbin holder with the
thread running off counterclockwise.
q Thread
w
w Bobbin holder
Guide the thread into the notch on the front of
the bobbin holder.
e Notch on the front
e
Draw the thread to the left, sliding it between
the tension spring blades.
r Spring blades
Continue to draw the thread lightly until the
t
thread slips into the notch on the side.
t Notch on the side
r
Pull out about 10 cm (4") of thread to the rear.
y
u
Reattach the hook cover plate.
y Thread
u Hook cover
12