Sharpening Wedge; Gearbox Lubrication- For Models Zi-Hs22Ez And Zi-Hs30(E)Z Only - Zipper Maschinen ZI-HS16E Manuel D'utilisation

17.3

Sharpening Wedge

This log splitter is equipped with reinforced splitting wedge which blade is specially treated. After
long periods of operation, and when required, sharpen the wedge using a fine toothed file
removing any burrs or flat spots on the edge.
17.4 Gearbox Lubrication–
for models ZI-HS22EZ and ZI-HS30(E)Z only
ZIPPER MASCHINEN GmbH
ZI-HS16E / ZI-HS22EZ / ZI-HS30Z / ZI-HS30EZ
www.Zipper-Maschinen.at
Waste oils are toxic and must never be
discharged into the environment. If
necessary, contact your local authorities
for information on proper disposal.
Change the hydraulic oil:
 Remove the oil drain plug to drain the oil from the
hydraulic system.
 Use a drip pan to collect waste oil and particles.
 Inspect the oil for metal chips. (Metal chips in the oil are
an indication of increased wear.)
 After the oil has been completely drained from the
machine, reinstall the drain plug.
 Top up the recommended fresh hydraulic oil via the oil
filler plug.
 After changing the oil, actuate the wood splitter several
times without actually splitting any wood.
 Use a dipstick to check the oil level.
The gearbox is pre-serviced using SAE90 gear oil.
 Drain the gear oil after first 25 hours of use and refill with
fresh oil as specified.
 Then change after every 250 hours of use or every six
months, whichever is earlier.
 After each oil change check that the correct amount of
oil has been poured into the gearbox.
 Check oil level every 8 hours: Oil level is correct if the
lower edge of the inspection hole is nearly covered with
oil.
MAINTENANCE
45