Bimar VPN500 Notice D'instructions page 19

7. Undo the screws (
the junction box (wiring and pipes)
using a screwdriver, and fit the end (
) of the ducting (electric wiring
and pipes) securely into the seat in
the lid and the ring in the top of the
junction box.
8. Connect the two plugs (3 and 6
poles) into the two sockets (3 and 6
poles) respectively,
correctly (take care that the pin fits
into the corresponding slot) and
secure them by tightening the ring-
nuts. Fit the two pipes into their
respective holes (N.B.: blue pipe into
blue fitting). When done, check that
the connections are firmly made and
correctly secured.
Before closing the lid of the junction
box, make sure that all connections
have been
correctly and stowed inside. Tighten
the screws with a screwdriver to
secure the lid.
USE
Before each use, check that the appliance is in good condition and that the power
cable is not damaged. If the power cable is damaged, it must be replaced by the
manufacturer or its after-sales service, or by a similarly qualified professional, to
prevent all risks.
Tank (maximum capacity of 14 L, autonomy 5-8 hours): use demineralised water
(free from lime), and without additives (essences, detergents or other substances);
the water temperature must not exceed 40°C and the water level must not exceed
the MAX level (marking: the highest water level). If wished, specific products to
prevent bacteria proliferation can be added.
Make sure that the pump is correctly fitted in place.
Fit the lid of the tank: check that it is completely, correctly inserted.
Connect the plug to the power socket.
) of the lid of
fitting
firmly made,
them
fixed