Publicité
Les langues disponibles
Les langues disponibles
USE
Warning:
before assembling the fan, check that it is disconnected from the power
-
socket. To assemble, refer to the illustrations below.
the fan may only be used if completely, correctly assembled, i.e. complete
-
with trolley, tank, protective grilles, etc. If in doubt, have the appliance
checked or have the operations performed by skilled staff.
To assemble, proceed as described and refer to the illustrations below.
1. Fit the fixed upright (complete with
handle, wiring and pipes) into the recess
in the lid of the tank, so that the handle is
at the back (side opposite the control
panel); check that the power cable and
pipe are in good condition and properly
stowed inside.
2. Connect the two plugs (3 and 6
poles) into the two sockets (3
and
6
poles)
fitting them correctly (take
care that the pin fits into the
corresponding slot) and secure
them by tightening the ring-
nuts. Insert the water pipe
(blue) into the hole in the
pump, pushing it fully down.
When done, check that the
connections are firmly made
and correctly secured.
respectively,
Publicité
