Publicité
Les langues disponibles
Les langues disponibles
2. Reinstall motor and shaft to seal plate using the four
through bolts removed in step 10 under "Disassembly".
NOTICE: Do not overtighten through bolts!
3. Slide new rotating half of seal onto shaft (Figure 2).
NOTICE: Do not nick or scratch the silicon carbide seal
face when passing it over shaft shoulder. Seal faces
must be clean and undamaged or seal may leak.
Slide ceramic
part onto
Press seal
shaft.
into cavity
Figure 2
4. Reassemble impeller, washer, and impeller nut.
5. Install new capacitor. See below for electrical connec-
tions to capacitor.
6. Inspect O-Ring carefully; replace if damaged. If it is not
nicked or scratched, clean and reinstall.
NOTICE: It is good practice to replace O-Ring each time
pump is serviced.
7. Reinstall capacitor cover, feeding wire through connector
hole, then reconnect cord wires to connector. Reference
color code markings.
Risk of electrical shock.
Can burn or kill.
Do not lift pump by
power cord.
Don't damage
Install washer,
rubber ring
then clip.
on groove
CORD LIFT WARNING
8. Fill motor with clean dielectric oil (Part No. U197-8A). To
allow room for expansion, oil level with cold motor should
be about 1/4'' (6 mm) above top of motor assembly.
Capacitor Connections (Single Phase Only)
Black
033 0893
Capacitor
Red
Black
For three phase wiring connections, see the "Three Phase
Wiring Connection" diagrams on Page 8.
1. Attempting to lift or support pump by
power cord can damage cord and cord
connections.
2. Cord may pull apart, exposing bare wires
with possibility of fire or electrical shock.
3. Lifting or supporting pump by power cord
will void warranty.
4. Use lifting ring or handle on top of
pump for all lifting/lowering of pump.
Disconnect power to pump before doing
any work on pump or attempting to
remove pump from sump.
032 0893
5
Green
Green
Red
White
Green
Red
Leads from
Leads From
Stator
Stator
White
Black
White
Black
Motor Leads
HT7 only
1308 1094
Publicité
