Cr-389 Remote Control; Using The Remote Control - Arcam A80 Manuel

Using the remote control

CR-389 Remote Control

The CR-389 remote control gives access to all functions
available on the front panel of the A80. It also has controls to
operate Arcam CD players, AM/FM tuners and DAB tuners.
The remote control transmits Philips RC-5 type codes.
These buttons are used to control tuner functions.
Note that the FM/DAB lights indicate into which mode
you are switching the remote control. The lights only
illuminate for five seconds to conserve battery power.
If neither light is illuminated this does not mean that the
remote control is not working!
These buttons do not apply to the A80.
Performs the same function as the
button on the front panel (see page 8).
Performs same function as the
panel. It allows you to use the remote's volume switch in the
same way you use the control dial on the front panel – to
adjust various amplifier settings (see page 8).
Note that pressing + corresponds to turning the
Control knob clockwise, – to anticlockwise.
Source selection buttons
These operate in the same way as the source selectors
on the front panel of your integrated amplifier.
NOTE: Remember to install the two supplied AAA batteries
before trying to use your remote control!
Do not place anything in front of the IR receiver on the left
of the A80, or the remote control may not work.
TUNER
(UP and DOWN)
ENTER
ENTER
SELECT
button on the front
SELECT
TUNER
FM DAB
Power/Standby
Toggles the amplifier between standby mode and full power
mode. The power indicator light next to the power button on
FM
MENU D SP
DAB
the front panel is red if the amplifier is in standby, amber while
the amplifier is powering up (this only takes a few seconds) and
1 9 2 10 3 11 4 12
green when the amplifier is powered up.
5 13 6 14 7 15 8 16
SP1 and SP2
MODE BAND
These buttons allow you to select and deselect the main (
and secondary (
SP1
(see page 6).
ENTER SP2 DISP
DISP (display)
SELECT
Cycles through the settings 'Bright', 'Off' and 'Dim'. Turning the
display 'Off' generally gives a slight improvement in sound quality.
Volume and
Press
of the amplifier.
PHONO AUX TUNER CD
Press
Both tape outputs and the headphone socket remain active.
AV TAPE VCR DVD
Mute is disabled either by pressing
volume.
AMPLIFIER
You can use the remote's volume control in conjunction with the
SELECT
RPT
PROG INFO
CD controls
These offer basic controls of Arcam CD players
CD
CR-389
SP2 ) sets of speakers attached to your amplifier
(mute)
to increase volume or to decrease the output volume
+ –
to mute the speaker connections and preamp outputs.
again, or by adjusting the
button to adjust balance, tone and amplifier settings.
)
SP1
A80/P80
9