Instructions For Installation - Whale SH2201 Instructions D'installation Et D'utilisation

6. INSTRUCTIONS FOR INSTALLATION
The Whale® Space Heater can be installed either inside the vehicle, Part Number: SH2201 (as in Fig. 2) or under the
floor, Part Number: SH2211B (as in Fig. 3), depending on which model has been purchased.
Interior Wall
Exterior Wall
Space Heater
Hot Air Outlet Duct
Gas Pipe
Vehicle Floor
Combustion Air Inlet
Exhaust Flue
Fig. 2 Internal Installation - SH2201
Hot Air Outlet
Cold Air Inlet
Gas Pipe
Vehicle Floor
Space Heater
Combustion Air Inlet
Exhaust Flue
Fig. 3 External Installation - SH2211B
To the Fitter:
Installation and servicing of this appliance must only be carried out by competent persons registered with the Gas
Safe Register (GB) or the relevant national organisation, in accordance with the relevant regulatory and safety
requirements.
Before installation, ensure that the appliance has been supplied in good condition and if damaged do not install.
A competent person must install the appliance in accordance with the appliance installation instructions. This
appliance is for use with LPG (see appliance data plate). Please check that the product is suitable for the intended
application. In particular, the installer must check the compatibility of the data plate information with the LPG
supply requirements of the vehicle.
Follow these installation instructions and ensure that all relevant personnel read the points listed below. Also ensure
that these operating instructions are passed on to the end user.
Please note: The appliance must be installed in accordance with any relevant regulations in the country where the
appliance is installed. For this appliance in Europe, the standard is BS EN 1949:2011 "Specification for the
Installation of LPG Systems for Habitation Purposes in Leisure Accommodation Vehicles and in Other Road
Vehicles".
Ventilation must comply with relevant national and/or local requirements.
5