Maintenance - Whale SH2201 Instructions D'installation Et D'utilisation

OPERATING INSTRUCTIONS
For operation of the Space Heater, a 12V d.c. supply must be connected at all times.
Red LED Light
Green LED Light
Selector Knob
Fan Only Operation. Turn the selector knob to the 'fan' position.
Gas Operation. Turn the selector knob to the 'gas on' (flame) position. There will be a pre-purge pause of approx. 30
seconds to allow any un-burnt gas to leave the flue. A green LED will light upon successful flame ignition. If there is
air in the gas supply line it may take a few attempts for the gas to ignite. See Section 9 for gas lockout re-setting. If
the ignition is not satisfactory the red LED will flash, refer to the Trouble Shooting Guide (see Section 9).
Switching Appliance Off. Turn the selector knob to the 'Off' position ( ).
Note: The fan will continue to run for 3 minutes to allow the Space Heater to cool down.
Adjusting The Temperature. Turn the temperature control knob clockwise to increase and anti-clockwise to reduce
the room temperature. The Space Heater will automatically turn itself on and off to maintain the desired ambient
temperature.
Note: The Control Panel incorporates a low temperature / frost protection setting. This can be activated by turning
the temperature control knob fully anti-clockwise.
Symbol
8.

MAINTENANCE

If the Space Heater has not been used for some time, dust may have settled inside the Space Heater and the
ducting. Run the Space Heater on the "Fan only" setting until it clears. The outside of the appliance should not
normally require cleaning. If it does, isolate the electrical supplies and wipe down with a soft, damp cloth only. Do not
use abrasive cleaning agents. Allow to fully dry before reconnecting the electrical supplies.
The Whale® Space Heater must be checked periodically by a Whale® Approved Service Centre / Technician, or
competent person, at least annually. This must be completed according to the practice in the country where it is used
and according to the Whale® instructions. Whale recommends that annual testing of gas soundness and combustion
is carried out by an accredited LPG gas engineer. The appliance contains ESD sensitive components and therefore
must only be opened by a Whale® Approved Service Centre / Technician (contact Whale® Support).
Fig. 32 Control Panel
Table 3: Control Panel Functions
Setting
OFF Space Heater will be off.
Space Heater will operate on gas. There will be a pre-purge time of
around 30 seconds before ignition. When the gas is lit, the green
Gas
LED will be illuminated. If the Water Heater fails to light for any
reason, the red LED will flash.
Fan Only Space Heater will operate on Fan only to circulate air.
Description
17
Temperature Control Knob
Refer to Trouble Shooting Guide (Section 9)
.