Instructions For Installation - Whale SH2201 Instructions D'installation Et D'utilisation

6. INSTRUCTIONS FOR INSTALLATION
The Whale® Space Heater can be installed either inside the vehicle, Part Number: SH2201 or SC2201 and SH2202
or SC2202 (as in Fig. 2) or under the floor, Part Number: SH2211 or SC2211 (as in Fig. 3).
Exterior Wall
Reset Button (Red)
Hot Air Outlet Duct
Vehicle Floor
Vehicle Floor
To the Fitter:
Installation and servicing of this appliance must only be carried out by competent persons registered with the Gas
Safe Register (GB) or the relevant national organisation, in accordance with the relevant regulatory and safety
requirements.
Before installation, you must ensure that the appliance has been supplied in good condition and if damaged do not
install.
A competent person must install the appliance in accordance with the appliance installation instructions. This
appliance is for use with LPG (see appliance data plate) and mains electric. Please check that the product is suitable
for the intended application. In particular, the installer must check the compatibility of the data plate information with
the LPG supply requirements of the vehicle.
Follow these installation instructions and ensure that all relevant personnel read the points listed below. Also ensure
that these operating instructions are passed on to the end user.
Please note: The appliance must be installed in accordance with any relevant regulations in the country where the
appliance is installed. For this appliance in Europe, the standard is BS EN 1949:2011 "Specification for the
Installation of LPG Systems for Habitation Purposes in Leisure Accommodation Vehicles and in Other Road
Vehicles".
Ventilation must comply with relevant national and/or local requirements.
Interior Wall
Fig. 2 Internal Installation - SH2201, SC2201, SH2202 or SC2202
Fig. 3 External Installation - SH2211 or SC2211
Combustion Air Inlet
Exhaust Flue
Hot Air Outlet
Cold Air Inlet
Combustion Air Inlet
Exhaust Flue
5
Space Heater
Gas Pipe
Gas Pipe
Space Heater