Parts List - Whale SH2201 Instructions D'installation Et D'utilisation

Where the open end of the exhaust flue terminates, three sides of the Underfloor Space Heater must be kept open
and not obstructed, and not contain through-floor ventilation openings.
The Space Heater, its gas supply, and flues for the products of combustion must be inspected in accordance with
national regulations or if these do not exist, the Space Heater manufacturer's recommendations. Whale advises that
this is carried out at least annually.
Please note: The Space Heater and Ducts will become hot. Please avoid anything directly touching the Space
Heater or Ducts.
5. PARTS LIST
The Whale® Space Heater kit contains:
Space heater and 4 screws
Space heater and 10 screws
Control panel / Room thermostat and 4 screws
3.5m control panel cable (retail only)
Warranty registration card
Instruction manual including installation templates
Instruction manual storage pocket, with adhesive fixing strip
Please note that the Whale® Space Heater requires a separate Flue Kit for installation. Exhaust Flues are available
in lengths of 0.75 metres, 1.25 metres and 2 metres. Inlet Flues are available in lengths of 0.75 metres, 1.25 metres
and 2 metres. A Vehicle in Motion Flue Kit is also available which specifically allows the Space Heater to be used
while the vehicle is in motion. For a full list of Flue Kits available, please contact Whale® Support.
Insulation
PCB
Heat Exchange
Case
Fan House Gasket
Motor Mounting Plate
Fan Hot Air
Fan Housing
Air Flow Sensor
Motor Gasket
Gas Overheat Thermostat
Fan Combustion Air Interface Box
Motor
Fig. 1 Components Drawing
Overheat Stat Insulation
Heat Exchange
Case Cover
Gas Heat Exchange
Heat Exchange Gaskets
Burner Gasket
Burner
Electrodes
Outer Box
4
SH2201 SH2211B
1
1
1
1
1 1
1 1
1
Case Lid
Gas Injector
Gas Train
Sealing Washer
End Plate Gasket
End Plate
End Plate
Connector
Olive
Nut