Publicité
Les langues disponibles
Les langues disponibles
End limit setting and self-learning
1- Press the
button until the light comes on (2 s). The display shows
2- Control the motor using the
- Pressing and holding the
- Pressing and holding the
3- Adjust the closed position using the
4- Press
to validate the closed end limit position and start the self-learning cycle. The door runs through a complete Open Close cycle.
- If learning was correct, the display will show
- If the learning cycle was not completed correctly, the display will show
During the learning cycle:
- If the door is moving, pressing any button will stop the movement and interrupt the learning mode.
- If the door is stopped, pressing
You can call up the learning mode at any time, even when the learning cycle has already been executed and the display shows
At the end of installation, it must be checked that the limitation of forces complies with appendix A of the standard EN 12 453.
Memorising remote controls (complete opening)
Up to 32 control channels can be stored. Running this procedure for a previously stored channel will clear it.
Example with TSA+ 4 channels remote control:
Example with Digicode Radio SA Hz:
Example with COLOR+ range transmitters:
At this stage in the installation process, the GM1000 motor drive unit is ready to run.
6
Operating test
Using the remote controls: The remote controls have a sequential operation (open / stop / close / stop...) or functionnal (3 keys).
Obstacle detection function: The detection of an obstacle during door opening will stop the door. The detection of an obstacle during door
Built in lighting operation: The light will come on every time the motor drive unit is operated. It will go out automatically after one minute once
the door stops. Repetitive use which causes the light to stay on continually may result in an automatic cut-off condi-
tion triggered by the thermal cut out protection mechanism.
8
or
buttons so that the transmission system runner moves to link up with the trolley and closes the door.
button closes the door. Release the
button opens the door.
or
buttons. Release the
.
once will exit the learning mode.
closure will reopen the door. Make sure that obstacle detection works when the door encounters an obstacle 50
mm from the ground.
button before the motor has time to force against the door.
button before the motor has time to force against the door.
.
2 s.
2 s.
2 s.
5 s.
1 s.
5 s.
1 s.
5 s.
PROG
1 s.
.
Publicité
