Simu GM1000 Notice Installateur Et Utilisateur page 22

Fitting the arm onto the door and the trolley
1
1- Release the trolley using the manual release cord.
2- Bring the trolley up to the door.
3- Attach the arm to the door bracket and the trolley.
Adjusting and fastening the opening travel stop
1
1- Release the trolley from the runner using the manual release mechanism and bring the door to the open position. Do not open the door
fully, but position it so that it does not reach its own travel stop.
2- Slot the travel stop into the rail then turn it by 90°.
3- Position the travel stop against the trolley.
4- Moderately tighten down the mounting screw.
Do not tighten the mounting screw all the way down. Excessive tightening can damage the screw and cause the travel stop
not to remain in place. Do not use the travel stops supplied with the transmission rail.
Fitting the chain retainer pads (for chain rails only.)
1
These pads are used to limit spurious noise linked to chain friction within the rail.
1- Position each of the pads in the fi rst hole in the rail after the travel stop.
2- Make sure that the pad is pressed in all the way so that its positioning pin is accessible outside of the rail.
6
2
90°
2
3
2
3
3
4
3