Publicité
Les langues disponibles
Les langues disponibles
Functions
• This Trix model complies with the regulations concern-
ing suppression of interference with radio and television
reception.
• An electronic overload protektion is build in to protect the
model.
• Triple headlights that change over with the direction of
travel.
• Built-in electronic circuit for oberation with an conven-
tional DC power pack, Trix Selectrix or NMRA DCC digital.
• The mode of operation is automaticaly recognized.
• Analog 14 volts DC, digital 22 volts AC.
Safety Information
• The full functioning of the decoder can only be guaranteed,
when the locomotive is operated with Trix Selectrix.
• Not suitable for locomotive controllers with pulse width
control.
• Not suitable for continuous train lighting on analog layouts.
• Not suitable for Trix ems.
• Pay close attention to the safty wrnings in the instructions
for your operating system.
Note for Selectrix Operation:
When a train enters a braking block that is turned on, and
enters it against the direction of travel, the indicator light for
running trains goes out in the braking block. After the bracing
block, the running light indicator comes back on.
6
Notes on digital operation:
• The operating instructions for your central unit (examplare:
Mobile Station) will give you exact procedures for setting
the different parameters.
• The values set at the factory have been selected to insure
trouble-free operation.
• This locomotive comes from the factory programmed for
the digital address „03" (Selectrix) / „03" (DCC).
• This locomotive with the settings made at the factory can-
not be operated with opposed polarity DC power in braking
track blocks. If this feature is desired, then you must do
without conventional DC operation (CV 29 / bit 2=0).
• Malfunctions resulting from changes to the factory settings
of the locomotive electronics are caused by the operator
and do not give grounds for complaint under our guarantee
or warranty obligaions.
• The programming for the Selectrix function is done in the
same mariner as discribed in the instructions for the 66838
decoder.
No warranty or damage claims shall be accepted in those cases where
parts neither manufactured nor approved by Trix have been installed in
Trix products or where Trix products have been converted in such a way
that the non-Trix parts or the conversion were causal to the defects and
/ or damage arising. The burden of presenting evidence and the burden
of proof thereof, that the installation of non-Trix parts or the conversion
in or of Trix products was not causal to the defects and / or damage
arising, is borne by the person and/or company responsible for the
installation and / or conversion, or by the customer.
Publicité
